JEDI
03-08-2007, 09:22 PM
I haven't picked up my Mag in a few years. Now, when i air it up, it leaks down the barrel. If I wiggle or push in on the bolt it stops, but upon firing it, or moving it around it leaks. Ok, here's the set-up. I forget some of the part names so please bear with me:
(Tuna Built) ULE Body, X valve, Level Ten bolt, bumper, medium spring with two finished flat ends...
Interior: Valve Tip is of the "wrench flats" variety (not the loosen with dime type) with one O-ring on it. After that is two small shims, then a spacer with one dot and two lines. Remove that, and there appears to be one white plastic washer.
Ok, the on/off assy. (ULE trigger type). From the outside - flat outer piece with one O-ring, then one shim, then lower half with a lower O-ring. On/off pin down the center.
Like I said it been some time since I used the Mag. Any help (or proper naming of parts :D ) would be greatly appreciated. Its a really nice all-black TunaMag that I'd love to see work again
ps. who makes the rail with the 3 cuts on either side, on the back end?
(Tuna Built) ULE Body, X valve, Level Ten bolt, bumper, medium spring with two finished flat ends...
Interior: Valve Tip is of the "wrench flats" variety (not the loosen with dime type) with one O-ring on it. After that is two small shims, then a spacer with one dot and two lines. Remove that, and there appears to be one white plastic washer.
Ok, the on/off assy. (ULE trigger type). From the outside - flat outer piece with one O-ring, then one shim, then lower half with a lower O-ring. On/off pin down the center.
Like I said it been some time since I used the Mag. Any help (or proper naming of parts :D ) would be greatly appreciated. Its a really nice all-black TunaMag that I'd love to see work again
ps. who makes the rail with the 3 cuts on either side, on the back end?