micro mag problem

[megapaint]

my micro mag rt takes about 2 seconds between shots to recharge have put in new orings but still same problem any ideas on what it could be thanks

[RRfireblade]

Sounds like the on/off pin is too long. Micros take a shorter than stock pin. Usually ~.700

[Coralis]

I had a similar problem with my micro a few years ago turned out to be the nickel plating had flacked off near the sear and managed to bind up the sear drove me nuts trying to figure it out.

Has it ever worked ? if not then you might consider a shorter on/off however if this a new problem check your sear and also unscrew your on/off and check the small oring between the two halves you could also check your regulator pin to make sure it doesnt have any impeding the airflow ( like a small bit of debris/teflon tape etc)


edit changed regulator piston to regulator pin

[megapaint]

it's always worked one of my favorite markers so this is a new problem will check out your suggestion thanks for the info

[athomas]

Most likely a piece of dirt caught somewhere.

[megapaint]

ok I've got the marker shooting 2 fast shots than it short strokes and needs 1-2 sec to recharge is it most likely my on off or my level 10 thanks for any info

[Coralis]

try going up one size carrier on your level 10, or removing the bolt a shooting some oil down the power tube.

[megapaint]

next size up leaks will try oil down power tube thanks

[Coralis]

if that doesnt work try replacing the oring

[flyingpootang]

Go to the next loosest carrier while using the same carrier o-ring (white) or remove 1 carrier shim if you using more than 3.

[athomas]

Change the bolt spring.