hjater
03-14-2007, 10:50 PM
After opening the grip on my emag i found the noid was wirerd the UK way...
Q1: is that a good thing or should i have it wired like the USA emags??? no disrespect to the UK.
I am guessing that the socket inside the grip at the top of the board has no function because of the way the noid was wired.
I would like to add the rf chip from pulse along with the loader. I do understand that i dont need the chip to use the loader. With that said after reading a few threads i thought i would try building my own harness from the warp feed interface cable. Which would have been connected to the noid socket at the top of the board. Because the noid is not connected to that socket Q2: can i connect it to the same place that the wires from the noid are.
Q1: is that a good thing or should i have it wired like the USA emags??? no disrespect to the UK.
I am guessing that the socket inside the grip at the top of the board has no function because of the way the noid was wired.
I would like to add the rf chip from pulse along with the loader. I do understand that i dont need the chip to use the loader. With that said after reading a few threads i thought i would try building my own harness from the warp feed interface cable. Which would have been connected to the noid socket at the top of the board. Because the noid is not connected to that socket Q2: can i connect it to the same place that the wires from the noid are.