missalinged logo

[GT]

I was wondering if this is a problem when logo is misalinged where the valve and the rest fo the body do not match? if it is can I fix it by using some blus locktight on the valve?

[TITAN]

its fine unless it is WAY misalligned, if your valve is really misalligned you may want to send it in to AGD, but never put locktite on the valve

[GT]

do you know what causes it? when i install it in the gun its fine but as soon as i clip off a few rounds it moves.

[TITAN]

maybe change your reg body o-ring to keep it tight

[Army]

It is not a problem, just a little quirk of the gun. The Z-lock in the body rail and pin in the valve will prevent it from going any further than it has. Don't worry about it:cool: