Air hose setup?

[jade_monkey07]

I own a Tac-one and i got the air hose factory setup with steelbraided line. its not in the way but i want to find a way of running it thats less unsightly and can still take out the x valve easily

Im just wondering how everyone else has thiers setup. pictures would be nice, or just a really good explanation

i cant seem to upload the image of it, says its not a valid image even though its a jpg and only 40kb

:shooting:

[Smoothice]

send me the pic and I will host it for you

lifes_a_garden_dig_it at hotmail.com

pm me to let me know you sent it to me.

[Cow123]

what service are you trying to upload to?

Here's mine: (not a tac, but still a mag)

http://i90.photobucket.com/albums/k246/Yawn_Monkeys/Paintball/DSC02308.jpg

[jade_monkey07]

Yeah thats basically the same as mine, if i was left handed there would be more i could do to get it out of the way

[Cow123]

You could run two lines.

One from the ASA into the bottom of the forgrip, the other from the top of the forgrip to the valve.

[Smoothice]

You could run two lines.

One from the ASA into the bottom of the forgrip, the other from the top of the forgrip to the valve.

That is what I did on my automag (now pneumag)

http://www.jayloo.com/files/pics/40000/IMAGE_00204_rs.jpg (http://www.jayloo.com/photo_gallery/show_pic/40663.html)

The hose going from the asa to the valve is 5 inches. If I ever get a 4 inch piece then it won't go above the powerfeed.

If you use marcroline then you can have it as short as needed. If you put a quick disconnect like mine then you don't need any slack to remove the valve

[jade_monkey07]

thats a good idea i hadnt thought of the quick disconnect on the valve. i think im gonna go that route

[Sammy Sandbag]

thats a good idea i hadnt thought of the quick disconnect on the valve. i think im gonna go that route

It won't fit on the valve side because of the mil-spec rails. I installed mine on the foregrip side, and it was still a very tight fit but worked.

[olinar]

this is why i hate ss hose but ihave to use them in order to run 1000 psi to my valve. does anyone know where i could get some macroline rated for more than 1000 psi?

[Coralis]

One thing if you run SS hose with a quick disconnect make sure the hose is long enough to give you a little slack ( notice most stainless set ups have a loop) so that the QD isn't in a bind and hard to operate

[Wickwire]

does anyone know where i could get some macroline rated for more than 1000 psi?

I use this (http://www.automags.org/forums/showthread.php?t=205578) on my Tac One. Works great.