View Full Version : Pneumag question
hmudd13
03-28-2007, 01:24 AM
I'm just curious about the routing of the low pressure hose, when you mount the LPR on the forgrip. Do you have to mill the rail?
olinar
03-28-2007, 01:34 AM
you sure do. this technique also allows for the cleanest install because there are no exposed hoses. you will need a small channel running for just behind the sear area to the front of the rail.
hmudd13
03-28-2007, 01:58 PM
Thanks, that's what I thought.
Smoothice
03-28-2007, 04:08 PM
Thanks, that's what I thought.
My pneumag has the hose run inside the rail.
I drilled a hole through the rail.
It required a long drill bit but is very clean and I don't have to worry about my hose coming out of the channel when cleaning.
hmudd13
03-28-2007, 05:49 PM
hmmm, that's sounds do-able too.
thanks.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.