View Full Version : 2X frames to fit a splash kit trigger?
punkncat
04-19-2007, 09:37 PM
Does anyone know of a 2x frame that will fit the old splash kit trigger well?
The ones that everyone cut their composite frames for....
I managed to fit a 2 finger splash splash into a Hyperframe. I just had to shave a teeny tiny bit off the bottom of the trigger. I also had to custom make a single finger trigger to put the 2 finger trigger onto it, but that was just a little work with a Dremel tool.
Tomorrow I'll look at my Intelliframe and see if it would fit into that without much of a hassle.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.