Jaan
05-12-2007, 12:10 PM
I've got a Hyperframe 'Mag and I'm using the Hyperframe on/off in a classic valve. With a level 7 bolt installed I had no problems. Now, with a level 10 bolt after shooting it about 100 times the edge is chewed up a bit.
The on/off pin measures exactly .7528 inches in length.
Is this damaged caused by the pin being too short, or too long...or is it something else?
Here are some close up pictures of the damage. Click on thumbnail for full size close ups...
http://img405.imageshack.us/img405/3007/bolt2tv0.th.jpg (http://img405.imageshack.us/my.php?image=bolt2tv0.jpg)
http://img19.imageshack.us/img19/8041/bolt3fa9.th.jpg (http://img19.imageshack.us/my.php?image=bolt3fa9.jpg)
Thanks!
The on/off pin measures exactly .7528 inches in length.
Is this damaged caused by the pin being too short, or too long...or is it something else?
Here are some close up pictures of the damage. Click on thumbnail for full size close ups...
http://img405.imageshack.us/img405/3007/bolt2tv0.th.jpg (http://img405.imageshack.us/my.php?image=bolt2tv0.jpg)
http://img19.imageshack.us/img19/8041/bolt3fa9.th.jpg (http://img19.imageshack.us/my.php?image=bolt3fa9.jpg)
Thanks!