On/Off two long or an O-ring problem?

[The_Don_83]

So the problem is when I try to take the valve out it moves in and out a little bit but gets caught on something...

I investigate by taking off the trigger screw and the valve is still inside the body. I look closer and notice the on/off pin is sticking out and is holding it inside the body. I press the pin in with a pencil and the valve comes right out...

Why is the on/off valve sticking out?

Thanks :cheers:

[Tunaman]

Make sure you fire the last shot and then pull the trigger to push the pin in. Some valves hold residual air.

[maglover728]

Also, pull the trigger once the marker is totaly de-gassed to push the on/off pin up before tring to slide the valve out.

[The_Don_83]

Make sure you fire the last shot and then pull the trigger to push the pin in. Some valves hold residual air.


Thats gotta be it! I normally do that, but with my new hopper I have been leaving the balls in the hopper while I take off the tank... causing me not to pull the trigger to de-gas...


Thanks Tuna... :headbang:


:cheers:

[The_Don_83]

Also, pull the trigger once the marker is totaly de-gassed to push the on/off pin up before tring to slide the valve out.



Thanks maglover728... de-gassing has to be the problem. :headbang:


:cheers: