View Full Version : emag lowers milling
I have discovered today that you cant just simply put emag lowers on the tac-one warp left body. The emag lowers need to be milled to accomodate the warp left.
Does anyone know what the best may to mill the arch into the emag lowers to accomodate the warp left? Would a dremel work?
athomas
07-01-2007, 05:08 PM
Only the rail needs to be milled, not the emag lowers. To mill the rail, just cut enough metal out of the rail to allow the warp feed to lay down without holding the body off the rail. You can use a dremel or a round file.
ok thnx for the advice... will try a dremel
Papa_Smurf
07-01-2007, 08:46 PM
this makes me sad, it'll eat it up if you don't have a wicked steady hand.
Luke can do it clean.
www.lukescustoms.com
i know what u mean.. I got it done fairly nice. (i could be a surgeon) :)
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.