Rapid Fire say what??

[Arbite]

I just got my new rpg paradigm pro in the mail today, =)

Nice looking gun but i have a problem, When i air it up (maxflo micro preset) hp reg,

and push the trigger (dryfire) its full auto, iam talking 12bps or something,

i cant get it to single fire, how come?

[Arbite]

i have now tried to fire it with balls, and its full auto maybe 4 shots, then it just , blows out air trough the pipe,

[StygShore]

Take one shim out of the ULT On/Off kit, and put some oil in the line before you turn the tank on so it cycles through the entire system.


Styg

[Arbite]

I have the ULT trigger

[StygShore]

:cool:


yeah that would be why I suggested you take a shim out of it.... or were you asking me if you have the ULT kit?


Styg

[Arbite]

sorry i mean i have the ULE trigger kit, or is that the same?

[StygShore]

same thing, nothin different about the trigger, its all in the ULT On/Off

unscrew the 2 halves and take one of the really thin shims out of it.

careful not to loose the teeny tiny on off pin in there.


Styg

[StygShore]

You know, its irritating when that happens. It leaves the shop in perfect working order after having been dry fired 200+ rounds. When it arrives, it does this.

E-mail me at [email protected] and I will help you tech it.


Geeze what kinda shoddy stuff you sending out the door Rogue?!?!?!?!?!? :rolleyes:



Styg

[Arbite]

i have mailed u

[Arbite]

StygShore, it didnt work,, tried removing all the shims,

[StygShore]

hehe only need to try removing 1 shim :)

Talk to Rogue, he put it together for ya, so he can probably troubleshoot the issue better than me :)


Styg

[Arbite]

well i removed one at a time. until there was no one left

[Arbite]

i tried to oil everything and screw all screws tight like he said, but no difference

[Arbite]

i have also tried 2 tanks with regs (both maxflo micro hp)

[StygShore]

did you take it apart or adjust anythign when you first got it?

Usually full auto is going to be attributed to the On/Off and Sear combination because it cant reset the sear to be ready to fire another shot. Adding or removing shims from the ULT kit will esentially make the on/off pin longer or shorter


How much pressure is in each of your tanks? ( not output, whats in them )

Styg

[Arbite]

the both have 3000 psi cause i have fillstation and 300bars dive bottles.

I didnt changed anything, i didnt take it apart until after i tried it and it didnt work,

Maxflo micro has 750-800 psi output pressure maybe thats the cause?

[StygShore]

neh 750-800 is fine - mags tend to run away more with higher input, not less.


you could try adding a shim to the ULT, eventually if you keep adding them, you wil ge tto the point it wont fire at all, maybe you are just on the low end of the setup.

Styg

[Arbite]

Took the reg pin out again and cleaned it and lubed it good, thanks Rouge for all the help

Your the best

Ps thanks for a great product