View Full Version : AutoCocker anti-chop ram
flyingpootang
07-18-2007, 12:56 PM
I just picked up a Karnivor and remember seeing a post on making an anti-chop ram mod by using a spring and? I think I seen it on pbnation and Mcarterbrown. Anyone have a link?
SummaryJudgement
07-18-2007, 01:06 PM
I remember seeing that. You were supposed to plug the rear air-inlet on the ram and place a pen spring (or some spring at least) between the rear of the ram and the ram-shaft end for return.
Sorry, no linky though.............. :)
flyingpootang
07-18-2007, 01:12 PM
Thanks fro trying I found it:http://www.pbnation.com/showthread.php?t=1986486 Not good for elctrocockers though :cry:
B2Ks have a anti chop ram what hits 20 bps
http://www.youtube.com/watch?v=pV_KMYS8C1Q
ThePixelGuru
07-18-2007, 03:25 PM
There's an anti-chop bolt with a spring between two halves of the bolt. Bolt just squishes itself down rather than chopping a ball. Dunno if you've heard of that, but it sounds like a way better option than putting a spring in your ram.
Eyes don't work for you?
behemoth
07-18-2007, 05:55 PM
A Karnivor has eyes.
It can also be tuned to pinch.
Why would you want to ghetto-fab your ram?
punkncat
07-18-2007, 07:51 PM
A Karnivor has eyes.
It can also be tuned to pinch.
Why would you want to ghetto-fab your ram?
I have heard for years people talk about tuning a cocker to pinch. I have done it, but got nothing close to proper velocity due to the way light rear spring I had to use to get the LPR low enough to actually pinch.
I think that for the average user the measure of fine tuning required is unreachable.
ZEROte
07-18-2007, 08:50 PM
i used to have a cocker that pinched. and it was all cause of the ram. the belsales 44 magnum. would never chop the ball.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.