View Full Version : Can anyone help me out?
gunslinger7
07-28-2007, 04:06 PM
Any of you know of anyone that will convert a centerfeed cocker into stockclass? Brad doesn't do it anymore, so I was wondering who does now..
Thanks!
Tom.
wetwrks
07-28-2007, 05:22 PM
Here are a few places to try. I havn't done business with any of them but they seem to do that kind of work.
http://www.whitewolfairsmithing.com/index.htm
http://www.jarrettcustommachining.com/index.htm
http://www.turtleinnovation.com/bodykits.htm
gunslinger7
07-28-2007, 05:57 PM
Out of those three, I've only done business with WWA. Thank you for he help, I have emailed all three of them. Anyone else?
Thanks,
Tom
going_home
07-28-2007, 06:11 PM
Out of those three, I've only done business with WWA. Thank you for he help, I have emailed all three of them. Anyone else?
Thanks,
Tom
Rainman on the MCB forum can do it.
lastone75@aol.com is his email.
He has his own section in the forum called Rainmans custom corner, does mods and anodizing.
http://www.mcarterbrown.com/forums/rainmans-custom-corner
punkncat
07-28-2007, 09:23 PM
Try CCM if they are stillin buisiness. Sorry drunk posting////
gunslinger7
07-29-2007, 08:38 AM
Thanks everyone!
Spaceman613
07-29-2007, 08:54 AM
K&P customs.
gunslinger7
07-29-2007, 09:04 AM
I've been to their website, but I can not find an email address. Could you supply me with one?
Thanks!
Tom
Spaceman613
07-29-2007, 09:28 AM
http://www.kpcustoms.net/cont.htm
gunslinger7
07-29-2007, 11:22 AM
Thanks! Any others?
So far 3 emails have been shot down... :(
gunslinger7
07-29-2007, 01:49 PM
The KPC email address does not exist according to Yahoo Mailer Daemon.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.