miro emag problems

[PBChappy]

well just put a new x-valve in my micro e-mag and a emag on/off, runing flatline reg set at 1k output, i am getting full auto effect every time you pull the trigger. mech, hybrid, and E modes all do the same thing. I dont know what is causing this and it makes the marker unsable after the 1st shot unless i could get something fast that could feed it, Vlocity cant keep up.

[DoritoBandito77]

The micro e-mag uses a different length on/off pin.
you can use the x-valve on/off but put the pin in that came w/the micro emag. its the shortest of all the pins

when i put the wrong pin in my microE it is hard to get the valve out of the body and i had to remove the body from the frame case the pin was to long

[PBChappy]

well if i dont have a mirco e pin does anyone know where to get one?

[athomas]

Pro Team Products can send you the proper pin.

Usually a pin that is too long will prevent the gun from firing at all. Full auto is usually a symptom of a worn sear or bolt, or a leaking on-off oring. I would try cleaning the on-off assembly and valve area first.