View Full Version : Rail question
ghostdog2019
08-17-2007, 03:02 PM
Is it possible to mill a splinter rail into a Karta?
Thanks all for any help
-Mike Brothman
punkncat
08-17-2007, 03:17 PM
Maybe time for the all too obvious reply...
Why not sell the splinter and use that money to buy a cheaper RT rail. Use the left over money to put towards the milling and anno......
ghostdog2019
08-17-2007, 03:21 PM
I know it is something a little more expensive to have milled but I do not want the holes associated with the standard RT rails or emag rails for that matter. From your answer however it sounds to be possible. Is this the case?
-Mike Brothman
Send me pics of the rail from the top down... and I will compare it to my 05 karta.
The karta rail is almost the same size as a shadow. All it needs is a little meat on each side... not much at all.
Id say no. There is a bit more external meat taken off of a Splinter Rail than your standard RT Pro/E-mag rail. Meat thats necessary in the machining process of a Karta.
I stand corrected. :hail:
ghostdog2019
08-17-2007, 03:58 PM
Well it seems that I may have to change directions with my mag. What rail besides a Karta do you guys think would look the best with a Karta body?
Thanks again all for the help
-Mike Brothman
zipity_Bop
08-17-2007, 04:05 PM
Well it seems that I may have to change directions with my mag. What rail besides a Karta do you guys think would look the best with a Karta body?
Thanks again all for the help
-Mike Brothman
they don't make any other rt rails....... w/o the holes?
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.