View Full Version : pnuemag rail milling help
hello just finished my pnuemag i love it already but i am going to tap my front asa and attach my lpr(tickler) there so i was wondering if anyone had suggestions or pics of how i should mill it for the line to run back to the grip and also how i get to the rail from the grip also i do not have a qev in would a qev help from chuffing. thx you guys are the best
Papa_Smurf
09-04-2007, 10:33 PM
1) use some .'s and ,'s
2) you can use a dremel, cut a lead to the slot and down into the frame you go.
Spider-TW
09-05-2007, 09:24 AM
1) use some .'s and ,'s
:)
1) Do you have a mill?
2) If not Luke has good turnaround times and does pretty work. Or dremel on.
3) A QEV is not necessary unless you have some other plumbing problem.
olinar
09-06-2007, 08:22 PM
just send it to luke, the turnaround time and proffesional work will definitely make up for whatever price you pay.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.