dsmit367
09-13-2007, 10:02 PM
I recently purchased an E-Mag from my cousin (some of you might know him, but I don't know what his ID here is) He gave me the nickel tour and sent me on my way home. I couldn't wait to get home a fire it, however it was leaking out the back of the valve, turned up the velocity and presto!!! The problem is, now I can get one or two, sometimes even a dozen shots, then it starts venting out the side (sounds like anyway). I have read the posts in the Level 10 thread (It does have a level 10) and I am just over whelmed. I read, then tinker, then read then tinker. I have had to resort to the ol' A-5 the past two times I have gone to play.... Any suggestions?
I turn the air off and on and the bolt/valve resets itself, however, that makes for a rough time when people are firing at you.....
And, just as a side note, I think my cousin said something about Tom setting this gun up himself. It is an E-mag valve, Lvl 10 bolt, Halo-fed Warp, with an Air America Armageddon valve set at 800..... bottle is a 68ci/45k (and it's even full)
Thanks in Advance!!
I turn the air off and on and the bolt/valve resets itself, however, that makes for a rough time when people are firing at you.....
And, just as a side note, I think my cousin said something about Tom setting this gun up himself. It is an E-mag valve, Lvl 10 bolt, Halo-fed Warp, with an Air America Armageddon valve set at 800..... bottle is a 68ci/45k (and it's even full)
Thanks in Advance!!