PDA

View Full Version : Piston pneumag ???


mag79
09-13-2007, 10:34 PM
Does any one know the length of the piston that goes in a mpa-3 for pneumag?
mag79
09-14-2007, 02:21 PM
:ninja:
questionful
09-14-2007, 03:50 PM
go to their site and find the pdf specs. sheet. I'd do it for you but I'm a bit lazy right now.
mag79
09-14-2007, 04:18 PM
go to their site and find the pdf specs. sheet. I'd do it for you but I'm a bit lazy right now.

I dont need the cleppard spec. I need to know what size pin to install
flyingpootang
09-14-2007, 04:35 PM
Luke cut's them around .475
http://lukescustoms.com/page0017.htm
mag79
09-14-2007, 06:44 PM
Thanks


Luke cut's them around .475
http://lukescustoms.com/page0017.htm