PDA

View Full Version : Emag Problems Fixed!


robnix
09-22-2007, 02:50 PM
So...I feel a little silly, but here's what I think the issue was. I dropped the shortened sear pin that comes with the 07 shadow rail down a sink drain so I replaced it with a standard sear pin. I'm thinking that I kept overtightening it, and it was either warping the rail a tad, or clamping down on the sear. The walls of the 07 shadow rail are very thin. Anyway, after loosening it up, it fires like a champ.

Full Auto, 15bps.

Thanks to everyone that offered tips and advice!

<embed src="http://www.youtube.com/v/v9M9IxVoelE" type="application/x-shockwave-flash" width="425" height="350"></embed>
BigEvil
09-22-2007, 03:38 PM
15 bps? Come on - rev that thing up to 20!
robnix
09-22-2007, 04:02 PM
15 bps? Come on - rev that thing up to 20!

:) That'll be my next trick. Need to save the air that I have for my emago project. Pnuematics should be in the mail today.
athomas
09-24-2007, 05:50 AM
Good job for figuring it out. :clap: Thanks for posting the results. It could help others with the same problem.
robnix
09-24-2007, 10:22 AM
Good job for figuring it out. :clap: Thanks for posting the results. It could help others with the same problem.

Thanks. It's always the little things and assuming that the problem is a moving part, and not the assembly.