Lostinthewoods
01-11-2002, 07:23 AM
I have a Tippmann Model 98 with a Psycho Ballistics electro kit insatlled. Eric, the owner of PB emailed me about duing a warp/intellifeed link to my board. I want to know if the following instructions are also going to provide power to my warp? I was planning to run two 9v batteries in paralell on the warp an was wondering if this setup with the described warp/intellifeed link would work together or creat too much voltage for the warp board. Thanks.
You should be able to run the red wire on the intellifeed to the red
input
from the battery on the board and the black wire on the intellifeed to
the
switch the tab marked no for normaly open, you may have to take the
switch
off the board and filp it over to see the marking. On one side of the
switch
the tabs are marked 1,2,and 3 and other c, nc, no (common, normaly
closed,
and normaly open)
You should be able to run the red wire on the intellifeed to the red
input
from the battery on the board and the black wire on the intellifeed to
the
switch the tab marked no for normaly open, you may have to take the
switch
off the board and filp it over to see the marking. On one side of the
switch
the tabs are marked 1,2,and 3 and other c, nc, no (common, normaly
closed,
and normaly open)