Emag wont boot with hall sensor plugged in.

[chettacheez]

So I just bought a cheap emag that needed some work and the gun will not turn on. I started checking voltages and while checking the hall sensor, I found when you unplug it the gun boots up, plug it back in and it shuts down. I was getting 5v at the sensor. Any ideas?

BTW its 1.37

[Thanna]

Could be that the magnet are too close to the hall sensor, and needs adjustment? Check out the xmod manual, i don't remember the specifics. :) good luck

[athomas]

So I just bought a cheap emag that needed some work and the gun will not turn on. I started checking voltages and while checking the hall sensor, I found when you unplug it the gun boots up, plug it back in and it shuts down. I was getting 5v at the sensor. Any ideas?

BTW its 1.37The emag 1.37 won't boot if the trigger magnet is too close to the HES. Try backing the trigger magnet out towards the front.

[chettacheez]

That fixed it, thanks a lot guys!