GriMachine
10-06-2007, 09:17 PM
Ok so I just finished my pneumag. The gun runs like a beast now that the trigger pull length of the my pneumag is super short. The only problem is that its not walkable. So heres my question. How could I lighten the tigger pull without taking away the psi needed to push the piston into the sear? By the way, im using the RT on/off assembly thats been drilled out to the standard mini mag on/off assemblys diameter in my mini mag bolt valve. If you know why i did that. But bottom line, how do I make the trigger pull lighter. If this helps heres my set up on a picture.
http://render2.snapfish.com/render2/is=Yup6lQQ%7C%3Dup6RKKt%3AxxqpDJ-Wt0frj%3DQofrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqp xQQoGxeQnxGlJxv8uOc5xQQQJlJP0ePn0lqpfVtB%3F*KUp7BH SHqqy7XH6gXPn0%7CRup6aQQ%7C/of=50,332,442
http://render2.snapfish.com/render2/is=Yup6lQQ%7C%3Dup6RKKt%3AxxqpDJ-Wt0frj%3DQofrj7t%3DzrRfDUX%3AeQaQxg%3Dr%3F87KR6xqp xQQoGxeQnxGlJxv8uOc5xQQQJlJP0ePn0lqpfVtB%3F*KUp7BH SHqqy7XH6gXPn0%7CRup6aQQ%7C/of=50,332,442