View Full Version : Solenoid question
Papa_Smurf
10-08-2007, 10:14 PM
As always there is another project to dig into, can you recommend a solenoid to use? Looking for a pancake noid, something like the hyperframe, if not the very same.
Thanks in advance guys.
CoolHand
10-09-2007, 12:45 AM
Check into the solenoids that were used in the Tippmann EA-5 conversions.
I want to say that WAS sold them, but it's been some time now, so I can't say for sure.
www.solenoidcity.com has some that get pretty close to the old hyperframe solenoids, but not quite. The hyperframe 'noids were custom wound for Centerflag. I want to say that Bicron manufactured them, but I could be totally FOS on that one.
Such as: Clicky (http://www.solenoidcity.com/solenoid/lowprofile/s-66-100p2.htm)
That ought to get you started.
:cheers:
BigEvil
10-09-2007, 04:45 AM
You can also use Ape Powershot solenoid that they sell for the Tippmann Egrips ... however, with their site down I have no idea how to contact them.
Fantom
10-09-2007, 11:19 AM
As always there is another project to dig into, can you recommend a solenoid to use? Looking for a pancake noid, something like the hyperframe, if not the very same.
Thanks in advance guys.
The Spyfer e-frame noid works fine in my Hyperframe.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.