PDA

View Full Version : on / off pin sticking


stevewar
10-20-2007, 09:34 PM
I have an xvalve and it had a ult in it, but I wanted to increase the sensitivity so I bought an regular on /off. When I gas the gun up and pull the trigger, the on / off pin sticks in the open position. Any ideas?
MANN
10-20-2007, 10:19 PM
what orings are you using? Did you lube it when installing? btw the ult is more sensitive than the regular one.
stevewar
10-20-2007, 10:36 PM
what orings are you using? Did you lube it when installing? btw the ult is more sensitive than the regular one.


Thanks man. The orings are the two inside the on / off and the small white one on the end of the pin. I did lube it up but didn't use much lube.


I should have said I want more trigger bounce. I'm running my tank at 1050 psi
MANN
10-20-2007, 10:37 PM
you would get better results using a quad oring. While a teflon one will work it is not good/great for reactivity.
stevewar
10-21-2007, 12:45 AM
you would get better results using a quad oring. While a teflon one will work it is not good/great for reactivity.

ok I have to admit you got me there. what's a quad oring? Thanks for the help by the way
Coralis
10-21-2007, 08:14 AM
Quad Oring (http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=195&categoryID=24)
Danterwhoo
10-21-2007, 07:25 PM
Quad Oring (http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=195&categoryID=24)


Do the quad orings go at the end of the on/off pin, where there are normally the two white orings around eacther hugging the pin?
Geronimo7
10-21-2007, 08:06 PM
Do the quad orings go at the end of the on/off pin, where there are normally the two white orings around eacther hugging the pin?

Yes, it takes the place of the oring getting the hug (smaller one ;) )