The next in my line of stupid questions..on/off pin?

[punkncat]

What on/off pin are Emags using an Xvalve using? Do they still use the "Emag" on/off pin? Will an RT on/off work in an X valve for an Emag?

I have seen an Xmag with the ULT give bad results, it didn't have enough push back to reset the solenoid.

So, IF an Emag on/off is required to make it work right, do I have to use the different O ring setup...IE the quad ring?

[BAZOOKA_Boy]

its the same on/off as the RT, just with a Quad oring on top

[MANN]

the on/off pin length in a rt/x/e valve is determined with the "lowers" you use it with. If using a mech .750 is a good starting point. If using electric .712 is a good starting point.

[madcrisis]

sry for the thread hijack sorta but can someone either take pictures or give me a link to the rt on/off with the oring set up and the emag on off with -ring setup.

thanks in advance

[Enemy]

mann is correct on his lenghts