View Full Version : Egomag question
FORDI
12-19-2007, 08:06 PM
I have been reading up about this conversion and think its a possibility for me to do it.
However i dont seem to see in any of the posts if it is possible to add eyes.
Is it???????????
Cheers guys
dixieoutfitter94
12-19-2007, 10:02 PM
I dont know why you could'nt add eyes but it would be hard to do, like drilling holes for an ebalde to go on a cocker...
robnix
12-19-2007, 10:49 PM
I have been reading up about this conversion and think its a possibility for me to do it.
However i dont seem to see in any of the posts if it is possible to add eyes.
Is it???????????
Cheers guys
I did an egomag without eyes and haven't seen a need for them with a L10 bolt. Shot a case through it last week without a break.
You could add them, I just don't think it's unnecessary.
p8ntbal4me
12-19-2007, 11:09 PM
1: Get a ULE body (or the like)
2: Get a rail (that works with the body
3: Send to Luke
4: Luke will drill the body for eyes
5: Luke will mill the rail for the eye wires and wire path
6: Make your eye wires long enough, solder the pigtail to the eyes.
Done.
~ P8nt
warbeak2099
12-20-2007, 12:24 AM
Yup, Luke can drill for eyes and mill for covers as well.
latches109
12-21-2007, 01:03 AM
Haven't found a need for them with the LX bolt.
FORDI
12-21-2007, 10:18 AM
Nice one guys.
What type of solenoid should be used as ive seen a couple on here that people have used.
Differences??????????????
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.