FOG
12-27-2007, 07:57 PM
My ptp micro.
http://i160.photobucket.com/albums/t193/acaptainn/PTPRHBUILT.jpg
http://i160.photobucket.com/albums/t193/acaptainn/ptprear.jpg
http://i160.photobucket.com/albums/t193/acaptainn/PTPLHSHORTSTOCK.jpg
Powerfeed lft single screw type has a feed block problem.P-balls are wedging agianst the plug at the bottom of the feedblock causing the balls to hang instead of dropping into the breech, Springfeed, Qloader anything that puts pressure on the balls make it worse.
I can stick a ten round tube in the feed neck an they will fall into the breach Much better than if the balls are being forced.It works pretty well with my ricochet on it but i still have to skake it sometimes.
Recomendations????
Before i fire up my DREMEL !
http://i160.photobucket.com/albums/t193/acaptainn/PTPRHBUILT.jpg
http://i160.photobucket.com/albums/t193/acaptainn/ptprear.jpg
http://i160.photobucket.com/albums/t193/acaptainn/PTPLHSHORTSTOCK.jpg
Powerfeed lft single screw type has a feed block problem.P-balls are wedging agianst the plug at the bottom of the feedblock causing the balls to hang instead of dropping into the breech, Springfeed, Qloader anything that puts pressure on the balls make it worse.
I can stick a ten round tube in the feed neck an they will fall into the breach Much better than if the balls are being forced.It works pretty well with my ricochet on it but i still have to skake it sometimes.
Recomendations????
Before i fire up my DREMEL !