GenX 3 Regulator Assembly

[clockworkmiller]

Does anyone know how to assemble one of these? My friend just got his and he cant figure it out.

[veteranmag]

What do you mean "assemble"? Do you mean how to do maintenance on it? Or do you mean putting it on your mag? What does it look like now?

The regulator has male screws on top that screws directly into your vertical ASA. There are two output holes near the top (that is where the pressure guage screws into) There are two holes because depending on your gun, when you completely screw in the regulator, one hole may be blocked by the trigger guard. So one hole is used for the pressure guage and the other is not used and capped with a metal plug.

At the bottom of the regulator is the input hole where you connect a standard 1/8" fitting/hose to your bottomline ASA (if you're using a screw-in nitro tank or co2) or directly to your nitro tank.

You adjust the input pressure on your regulator using the knob at the very bottom of the regulator (you may need to loosen the two long velocity locking allen screws at the bottom). Once you get the desired setting, you tighten the locking allen screws.