Hooking mako and rev.

[mag_pbg]

I was wondering if there was any way to hook up my rev. to the Mako frame¿

[Magsrule3]

I think it is possible. I saw someone with intellifeed on their Hyperframe. I think you would have to "interupt" one of the wires in it and solder a wire going to the revvy. I dont know which wire would send off the right pulse though.

[Have Blue]

No need to 'interrupt' - just solder a wire onto the pin of the micro that controls the solenoid. Run that wire to the center pin of the ZTX604 transistor in the Revvy. Then run a ground wire back from the Revvy to the board in the frame.

The only drawback is that the frame will only trigger the solenoid for maybe 6-9ms, which may not be enough time for the Revvy paddles to start moving.