Morlock settings n a EP mag

[BREAD_DA_PAINTER]

I am using a mini morlock board in my EP mag.. I am wondering what settings u guys used.. mostly the fastest possible with out burning up my noid... its a smc noid....

I will have a thread up with pics some time this weekend.....


:cheers:

[p8ntbal4me]

I am using a mini morlock board in my EP mag.. I am wondering what settings u guys used.. mostly the fastest possible with out burning up my noid... its a smc noid....

I will have a thread up with pics some time this weekend.....


:cheers:

What SMC solenoid are you using?

Whats the voltage for the solenoid?

Whats the cV or VAC pressure (max) on the noid?

Whats your LPR set for input pressure?

What are you using for an actuator/ram? (Cyberave68 MPA-3)

How long is the hose from the solenoid to the actuator?

Are you using a QEV?


Give me answeres to those questions and I can get you into a better setting bank based on what MROF you want to have.

~ P8nt

[BREAD_DA_PAINTER]

Thanks P8nt


i will get rb211 to give all these specs tomorrow.. the marker is at his house and with today being his b-day he is out all night...

once again thanks..

[Ruler_Mark]

hey when i ran that noid(if this is the noid i sold you then the same exact noid) on my ep mag i was using a an 4 8 or 14 dont remeber exactly but thoose numbers are familar. it was setup pretty dam close to what you have, I was able to have the noid run any mode i wanted only tested it up to 20 bps(i was a noob back then and didnt have my lvl x tuned good enough to go any faster nor a tank that could keep up).