Stuck on autofire

[Misha]

Hi,

Dry-fired my Tac One today and could not get a single shot out of it. Just auto bursts. It is a new Tac One with Ule. I tried to barely squeeze the trigger and still it would fire a burst.
I use compressed air.
Thanx for any info in advance

~Misha

[athomas]

Check to see if all your on-off orings are in place and dirt free.

[darqueMeye]

do you have the ULT installed? if so that may be the cause. Try changing the number of shims inside the ULT. If there are more than 4 shims in there its too many. Usually 4 is the max you want. My ULT runs great with 3. Its something you just have to tinker with till you get it right.

[michbich]

When you said Tac one ULe, did you mean ULT? If so, darqueMeye is right.

[Misha]

Yes ULT, sorry my bad.

I did not get a manual for reassembling my Tac One. There was a "micro CD" mentioned but i dindnt get it. How do i check for those shims ?

[varq]

u need to take the X Valve out. (take out the one screw in the back) make sure your pull trigger and the gun is degassed of course... when you take the valve out on the underside you will find the ULT.. pull it out. the grab each end with each hand and pull apart while unsrewing it.... then count the shims... 3 or 4 should do it. also make sure ur gun oiled.