Sydarm Recharge Problem

[Imp_MoFo]

I have an AGD sydarm with a recharge issue that I caused. I have only acquired it a couple of months ago... worked fine until I had to clean it after a rainy day of play. I must have put it back together wrong...

Symptoms are:

First shot shoots fine...

Second shot hardly leaves the barrel... If I let it sit for like half a min I get some velocity back but not much...

So Ya its the recharge... I check to make sure the pin in the valve is all good I've tried reassembling it right once more but I still have the same problem..

Can somebody point me in the right direction... Sadly i'm not too firmiliar with mag style valves but i'm working on changing that...

-Nick

[Castro #66]

Scrap it. I can take care of that for you, PM'ing my address here in a sec...


Really though, perhaps it's a blockage.

Without more information I'm afraid I can't be more helpful at the moment. Funny thing is, if I had it in front of me, I'd have fixed it already... :p

[secretweaponevan]

Did you clean all the grease off of the reg piston? It needs some grease in order to allow recharge at decent levels.

[questionful]

Try flipping the spring pack around.

[Imp_MoFo]

Thanks for the breakdown... I'll have some time to look into it tonight :shooting:

[athomas]

Did you put the on-off top in upside down?

[xxkylexx]

Too much oil on the bolt/bumper area can cause it to suction stick ...

[AnthonyDStone]

Lube it,If its Too dry it won't recharge quickly because of friction.

Tony