View Full Version : Re-anodizing Freak Barrels
dre1919
04-22-2008, 09:42 AM
This doesn't cause any problems does it? I just purchased the Freak Kit inserts and case from a gentleman here on AO, and I am going to pick up a front and back barrel piece on the cheap from eBay (new in bag even). But, they will need to be re-anodized (the barrels, not the inserts) :) to match my gun. Does this cause any tolerance issues with the inserts?
Thanks,
Andrew
secretweaponevan
04-22-2008, 11:55 AM
This doesn't cause any problems does it? I just purchased the Freak Kit inserts and case from a gentleman here on AO, and I am going to pick up a front and back barrel piece on the cheap from eBay (new in bag even). But, they will need to be re-anodized (the barrels, not the inserts) :) to match my gun. Does this cause any tolerance issues with the inserts?
Thanks,
Andrew
Smart Parts' precise tolerances should leave you plenty of leeway. Like threading a barn.
dre1919
04-22-2008, 12:25 PM
Hahahaha :ninja: Thanks!
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.