View Full Version : PTP Question
TeamJackal37
05-06-2008, 10:39 AM
Does all PTP vertical feed micromag have threaded feedneck? what size feedneck?
for 99% of them no. There was 10 threaded feedneck ones availible, and iirc one is for sale right now in the bst section.
Some people have replaced the pressed in feedneck with another pressed in one.
TeamJackal37
05-06-2008, 10:52 AM
for 99% of them no. There was 10 threaded feedneck ones availible, and iirc one is for sale right now in the bst section.
Some people have replaced the pressed in feedneck with another pressed in one.
How can you pressed in feedneck with another pressed in one?
TeamJackal37
05-06-2008, 10:55 AM
I have non threaded feedneck, My halo wont fit, Egg too loose, I'm trying find a solution
I have non threaded feedneck, My halo wont fit, Egg too loose, I'm trying find a solution
have someone press fit another feedneck in it. I am doing the same thing with my golden micro Emag.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.