Spencer
06-07-2008, 03:37 PM
I know there is a sticky around here but I can't seem to find it..
I need to know from whom can I get the parts from?
Where that video is that shows how to do it, and im sure there directions somewhere here on how to do it? Should I send it off to get it done?
How do they put the LPR in the trigger frame? I mean how is it connected to an airsource? I have seen pictures, only thing I could think is if they are drilling through the grip and into the asa.
What can I expect? Im good with fixing stuff, but is this a finicky mod? Shooting a mag I like my stuff to be reliable and cause no problems later on.
Should I use an RT On/Off or a ULT On/Off? I have both so which would be better? Im sure the ULT would require less pressure which means that it may translate into less pressure on the trigger pull..
And trigger stops, are they needed? Are they used? And how do you get one? Install it on the trigger frame or get a trigger with stop?
OFF SUBJECT..
If using a ULT On/Off and my trigger leaks when I put a little pressure on it, should I add or remove one shim?
I need to know from whom can I get the parts from?
Where that video is that shows how to do it, and im sure there directions somewhere here on how to do it? Should I send it off to get it done?
How do they put the LPR in the trigger frame? I mean how is it connected to an airsource? I have seen pictures, only thing I could think is if they are drilling through the grip and into the asa.
What can I expect? Im good with fixing stuff, but is this a finicky mod? Shooting a mag I like my stuff to be reliable and cause no problems later on.
Should I use an RT On/Off or a ULT On/Off? I have both so which would be better? Im sure the ULT would require less pressure which means that it may translate into less pressure on the trigger pull..
And trigger stops, are they needed? Are they used? And how do you get one? Install it on the trigger frame or get a trigger with stop?
OFF SUBJECT..
If using a ULT On/Off and my trigger leaks when I put a little pressure on it, should I add or remove one shim?