View Full Version : Anodizing Questions
sffudapparel
06-09-2008, 08:12 PM
Is it possible to anno the back velocity adjuster on my x valve? Possible is a bad word, as anything is possible, but is it feasible and reasonable to anno it or is it going to be tough to get it done right and still have a functioning x valve?
Also, who annos out here other than bazooka boy? I might need to talk to someone about annoing some pieces, but not a whole gun
Thanks all
-Ty
questionful
06-09-2008, 08:15 PM
The velocity nut is stainless steel (very soft steel, I stripped the 1/8 hole in mine :( ). You can only anodize aluminum. However, it is not a critical part, so if you were to have one made out of aluminum, you could anodize it no problem.
blitzkriegboom!
06-11-2008, 08:07 PM
gruntbull is a pretty high quality and good service annoer
ive heard the fool is pretty decent as well
look around on dealers forum, prolly a few more out there
st6212
06-11-2008, 09:53 PM
You can't anno stainless, but you can put a black oxide finish on it. Same type of finish on black grip screws and set screws.
Gruntbull offers the service I believe.
Making a new velocity adjuster out of aluminium would certainly save quite a bit of weight, plus able to anno it.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.