jgilk1
08-11-2008, 01:22 AM
I just bought a view loader force hopper (the basic model with out eyes)
and am wanting to modify it so i can activate the hopper every time i fire the gun to save battery and reduce noise from the hopper.
What i am wanting to do is intellifeed the hopper to save battery
this is project i am looking @ conquering but with some changes.
http://www.airgundesignsusa.com/downloads/eureka3.pdf
yes this is agd tech
just so you all know i am shooting a cocker with a hinge frame so don't even mention agd intelli frame as an option (it wont work i tried)
Any ways what i was thinking was to jumper off the circuit board to some sort of switch either mounted behind either the trigger or under the sear but i don't know what kinda switch to use my initial thought was an momentary pressure switch but it just tears up the look of the marker
heres the circuit board in the hopper the white one (labeled jumper of some sort) is a jumper circuit it is just a red wire looped to both sides of the actual jumper
http://i286.photobucket.com/albums/ll114/jgilk1/forcehoppercurcitboard.jpg
The only problem i have is what kind of switch i could use and where i could mount it to activate the hopper i know the same switch in the pdf would work but i would have to mill the frame and drill several holes to mount the switch
Again in case you missed this it's on an autococker with a 45 hinge frame not a automag with an intelliframe.
and am wanting to modify it so i can activate the hopper every time i fire the gun to save battery and reduce noise from the hopper.
What i am wanting to do is intellifeed the hopper to save battery
this is project i am looking @ conquering but with some changes.
http://www.airgundesignsusa.com/downloads/eureka3.pdf
yes this is agd tech
just so you all know i am shooting a cocker with a hinge frame so don't even mention agd intelli frame as an option (it wont work i tried)
Any ways what i was thinking was to jumper off the circuit board to some sort of switch either mounted behind either the trigger or under the sear but i don't know what kinda switch to use my initial thought was an momentary pressure switch but it just tears up the look of the marker
heres the circuit board in the hopper the white one (labeled jumper of some sort) is a jumper circuit it is just a red wire looped to both sides of the actual jumper
http://i286.photobucket.com/albums/ll114/jgilk1/forcehoppercurcitboard.jpg
The only problem i have is what kind of switch i could use and where i could mount it to activate the hopper i know the same switch in the pdf would work but i would have to mill the frame and drill several holes to mount the switch
Again in case you missed this it's on an autococker with a 45 hinge frame not a automag with an intelliframe.