E-mag question...

[SithSteve]

I was wondering if an E-mag on/off assembly will work in an X-valve? Or, do I have to just replace the on/off pin in the RT assembly that is already on the valve?

Thanks!

[Geronimo7]

Yes you can use your current r/t on-off. You only need to replace the pin with a .712 pin and change out one o-ring with the quad o-ring.

[Geronimo7]

This is the o-ring you will need
http://store.airgundesignsusa.com/index.cfm?fuseaction=catalog.prodInfo&productID=195&categoryID=24
it replaces the smaller of the two in the top of the on/off

AGD sells them in packs of 4, but you could probably get a single one from Tuna along with the .712 pin.

[SithSteve]

Thanks!

[TwilightG]

From my own experience, I found this to make my X-Valve highly reactive. Since the pin is shorter, it requires a shorter trigger pull and gives as much return force as an RT.

My DXS tank only puts out about 800psi and I easily sweetspot the trigger with a respectable cycle rate.

[dark blade]

true fact... i run a HP myth and its preset to about 900, but since its a myth it has a great flow... much better than any other tank reg

and i can get extreme bounce in hybrid and mech mode

its wonderful