phatty123
08-13-2008, 10:07 PM
This IR3 Fly was my 1st custom project. I bought it off of AOG for 60 shipped. It had a bad board and was missing the solenoid clamp and the blacl blank inbetween the breech and the solenoid. I bought the clamp and the blank from fma for about 18 bucks totall. That fixed the huge gushing leak from the solenoid. I then bought a Universal T Board. I was on a budget and for about 60 shipped it seemed like a good deal
This is where I started
http://i13.photobucket.com/albums/a281/phatty123/SS855334.jpg
http://i13.photobucket.com/albums/a281/phatty123/SS855336.jpg
This is the the board and the circuit board blank from radio shack that will be the trigger mount.
http://i13.photobucket.com/albums/a281/phatty123/SS855337.jpg
This is a close up of the grip
http://i13.photobucket.com/albums/a281/phatty123/SS855340.jpg
This is when I cut and sized the board the 1st time.
http://i13.photobucket.com/albums/a281/phatty123/SS855346.jpg
I took a female plug off the old ir3 board so i wouldnt have to cut the solenoid wires
http://i13.photobucket.com/albums/a281/phatty123/SS855347.jpg
I went with JB welding the 50g micro switch onto the board
http://i13.photobucket.com/albums/a281/phatty123/SS855350.jpg
http://i13.photobucket.com/albums/a281/phatty123/SS855356.jpg
This is the pile of junk comeing together
http://i13.photobucket.com/albums/a281/phatty123/SS855354.jpg
This is everything crammed into the frame. The wires will be shortened and packed in neater tomorrow, but for now I just soldered it together and got it working.
http://i13.photobucket.com/albums/a281/phatty123/SS855359.jpg
This is where I started
http://i13.photobucket.com/albums/a281/phatty123/SS855334.jpg
http://i13.photobucket.com/albums/a281/phatty123/SS855336.jpg
This is the the board and the circuit board blank from radio shack that will be the trigger mount.
http://i13.photobucket.com/albums/a281/phatty123/SS855337.jpg
This is a close up of the grip
http://i13.photobucket.com/albums/a281/phatty123/SS855340.jpg
This is when I cut and sized the board the 1st time.
http://i13.photobucket.com/albums/a281/phatty123/SS855346.jpg
I took a female plug off the old ir3 board so i wouldnt have to cut the solenoid wires
http://i13.photobucket.com/albums/a281/phatty123/SS855347.jpg
I went with JB welding the 50g micro switch onto the board
http://i13.photobucket.com/albums/a281/phatty123/SS855350.jpg
http://i13.photobucket.com/albums/a281/phatty123/SS855356.jpg
This is the pile of junk comeing together
http://i13.photobucket.com/albums/a281/phatty123/SS855354.jpg
This is everything crammed into the frame. The wires will be shortened and packed in neater tomorrow, but for now I just soldered it together and got it working.
http://i13.photobucket.com/albums/a281/phatty123/SS855359.jpg