View Full Version : CP ASA disassembly/adjustment
GoatBoy
09-27-2008, 10:07 PM
Does anyone know how to adjust one of these ASA's?
http://images.actionvillage.com/inc/images/large/031-6220-06.jpg?qlt=100&cell=175,300&cvt=jpg
For some reason, mine went out of adjustment today and wouldn't properly press the pin valve in when screwed in. I managed to get it working, but it was starving my gun all day. It's worked fine before, so something must have gotten jarred recently.
How do I get in there and adjust that pin travel?
Thanks!
Ruler_Mark
09-27-2008, 10:10 PM
needle nooser's take the center brass piece out, then it is very logical i forget the exact steps.
Sanchito
09-27-2008, 10:10 PM
thats weird.
mine is leaking air out the bottom through the bleed hole, and will never quit. i also cant figure out how to stop it.
Dewok82
09-27-2008, 10:34 PM
http://www.customproducts.us/downloads/maintenance_guide_2k5_on-off.pdf
http://www.customproducts.us/downloads/maintenance_guide_dm_on-off.pdf
GoatBoy
09-28-2008, 12:59 AM
Doh, why didn't I think of that. Thanks for the links.
Hrm... so, apparently, there isn't anything to be adjusted. Which leaves me wondering why the thing started acting up today...
thats weird.
mine is leaking air out the bottom through the bleed hole, and will never quit. i also cant figure out how to stop it.
Not sure this is the issue but 8 times out of 10 a leak through the bleed hole on the bottom is a bad o ring on the tank. Check it for nicks or deformities
Doh, why didn't I think of that. Thanks for the links.
Hrm... so, apparently, there isn't anything to be adjusted. Which leaves me wondering why the thing started acting up today...
check the o rings. they are always the culprit!!!!
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.