Using the Automag in a school project

[DanMan]

I am, along with 4 other students, doing a end of semester project where you have to model up a mechanical object. We are going to do my mag, and i was wondering if there were any x valve, intelli frame, or lvl10 dimensioned schematics. We have to measure each dimension our selves and make our own sketches as part of project, but the reference would be nice as a lot of the dimensions are going to be hard to determine. I am guessing that fully dimensioned drawings are going to be hard to come by but maybe Tom can comment on that?
Thanks
Dan

This is also posted in the tech forum, if this is not ok, just delete which ever one.

[Rudz]

I would post this in the workshop, I'm very sure that someone has schematics for mag parts

[DanMan]

ah good idea! i hardly go over there so i forget about it sometimes

[neppo1345]

Wouldn't that be...cheating?

[DanMan]

No, because we still have to make the digital 3d model with full feature tree. Also, with the tools at my disposal to measure the marker with (esp the valve) some of the features will need to be simply looked up instead of measured. The information will be used for when this case arises, not as a general cheat sheet.

[doc_Zox]

http://haveblue.org/tech/automag/

http://haveblue.org/tech/automag/sluggo2.jpg

[DanMan]

humm interesting. Thanks, i will take a good look at that!