halo13
01-27-2002, 11:01 AM
I'm sure that this question has been asked before, but the serach results arn't turning up much. So, here is the question. Is there a chance that AGD will make a Z-grip for the E-mag?
The solenoid AGD uses, is of a size and power need that precludes it's use in a Zgrip. If AGD can find a much smaller solenoid, that has the same strength, quality, and power requirements, and perhaps works on a push instead of a pull, then it would not be a problem to Z an Emag.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.