Spyder to Autococker Barrel Adapter?

[Bagheera]

Do these thread adapters hurt accuracy at all, especially when using sized bores that then adapt to specific barrels?

[Ace12GA]

I used a lapco one for a while, and I didn't notice any performance loss. A note, when using with a Tac One body, the adapter is slightly shorter than the where it threads into the body, so if the barrel unscrews instead of the adapter when taking it off, good luck getting the adapter out. ;)

[paint magnet]

They usually don't have much effect, since the ball still has the rest of the barrel to stabilize it once it goes through the adapter. I would imagine the adapters are rather large bore though.

Think of it like an extended breech.

[LK-13]

you wont even know the Lapco one is there.

[Bagheera]

Luckily it's not a Tac-One body (though I wish it was.) It is a Warp Right ULE body, so I won't have to worry about getting stuck. I've find a DOP for a few dollars less than the Lapco, is the DOP any good, or should I get the Lapco?

So, the adapter won't affect the bore-backs at all? That's good news.