dyepb
01-13-2009, 05:04 PM
Hey guys,
I gassed up my xvalve emag (with some oil) after about 2 years of no play, and it wouldn't fire manually or electrically. The electrical component LED was working fine, and was registering my trigger pulls.
When I tried to take the valve out, the on/off pin was stuck extended into the rail, so I couldn't slide it out. I had to remove the whole body off of the rail. I pushed the pin back in (took some force), and gassed the marker again. As soon as it was pressurized, it seemed to have fired once on its own, but would not fire again after that. Upon removal of the valve, the same thing had happened, and the on/off pin was stuck extended into the rail.
Any and all help would be appreciated.
I gassed up my xvalve emag (with some oil) after about 2 years of no play, and it wouldn't fire manually or electrically. The electrical component LED was working fine, and was registering my trigger pulls.
When I tried to take the valve out, the on/off pin was stuck extended into the rail, so I couldn't slide it out. I had to remove the whole body off of the rail. I pushed the pin back in (took some force), and gassed the marker again. As soon as it was pressurized, it seemed to have fired once on its own, but would not fire again after that. Upon removal of the valve, the same thing had happened, and the on/off pin was stuck extended into the rail.
Any and all help would be appreciated.