PDA

View Full Version : Sear Questions for ya'all


kwood
03-19-2009, 05:16 PM
will a AM/MM sear work with a....
Xvalve (ULT)
Dallara rail
Logic 90* frame
???
i am needing a sear and am trying to make sure i am looking for the right part
secretweaponevan
03-19-2009, 05:26 PM
will a AM/MM sear work with a....
Xvalve (ULT)
Dallara rail
Logic 90* frame
???
i am needing a sear and am trying to make sure i am looking for the right part

Does the Dalara rail have a threaded hole in the side of it for a sear pin? If so you need an RT sear.

If not, an AM/MM sear will be fine.
kwood
03-19-2009, 05:37 PM
no it does not
the reason i need to get a sear is because my current rail (RPG wave rail) does have a little threaded sear
pin and spacer in the sear
and thats the sear i was planning on using until i discover the differences between the rails

so the sear that uses a lttle ovally looking pin is the AM/MM sear and the ones with the sear pin threaded to the rail are the RT ones
secretweaponevan
03-19-2009, 05:39 PM
no it does not
the reason i need to get a sear is because my current rail (RPG wave rail) does have a little threaded sear pin and spacer in the sear
so is that allen key threaded sear pin combo what makes an RT sear an "RT" sear?
no difference in the trigger pin length?

Correct, the difference is the threaded sear pin.
Trigger rod length is roughly the same for all mags. The differences are taken up by the threading.
kwood
03-19-2009, 05:41 PM
awesome, problem solved!!!
thanks for your help :cheers:
jrod
03-19-2009, 06:34 PM
awesome, problem solved!!!
thanks for your help :cheers:
I have a sear and pin if you are interested. PM sent.