GoatBoy
05-06-2009, 02:19 AM
I've had this little side project on my mind for a while now, and I figure it's time try to get it rolling.
I picked up two Ariakon ACP 2.0 clips from here a while back (can't even remember from who).
I want to mount it on my mag on the side:
http://lh6.ggpht.com/_gAgyL4R33AI/SgEtFwiJGaI/AAAAAAAADkw/Ya2BBGpcjjw/s288/IMGP2020.JPG
My mag also happens to have the wings milled down, so it's just straight all the way across.
I sat down tonight and sketched up the clips (in Google Sketchup) that will screw into the front grip holes as well as the sight rail holes in front and behind the warp feed hole, and hopefully will be able to use the clip on there.
http://sketchup.google.com/3dwarehouse/download?mid=e805021862b02dc931c37e5f0b2fba3a&rtyp=lt&ctyp=other&ts=1241658266000http://sketchup.google.com/3dwarehouse/download?mid=8be3d07ac9c9723031c37e5f0b2fba3a&rtyp=lt&ctyp=other&ts=1241658645000
I've never actually seen an Ariakon ACP 2.0 in person, but I figure this is how the clip is mostly mounted on; with 3mm half-circle type nubs.
So uhhh... who knows how to make parts?
I picked up two Ariakon ACP 2.0 clips from here a while back (can't even remember from who).
I want to mount it on my mag on the side:
http://lh6.ggpht.com/_gAgyL4R33AI/SgEtFwiJGaI/AAAAAAAADkw/Ya2BBGpcjjw/s288/IMGP2020.JPG
My mag also happens to have the wings milled down, so it's just straight all the way across.
I sat down tonight and sketched up the clips (in Google Sketchup) that will screw into the front grip holes as well as the sight rail holes in front and behind the warp feed hole, and hopefully will be able to use the clip on there.
http://sketchup.google.com/3dwarehouse/download?mid=e805021862b02dc931c37e5f0b2fba3a&rtyp=lt&ctyp=other&ts=1241658266000http://sketchup.google.com/3dwarehouse/download?mid=8be3d07ac9c9723031c37e5f0b2fba3a&rtyp=lt&ctyp=other&ts=1241658645000
I've never actually seen an Ariakon ACP 2.0 in person, but I figure this is how the clip is mostly mounted on; with 3mm half-circle type nubs.
So uhhh... who knows how to make parts?