Z-Grip & Foregrip Extender

[rhino]

I have seen several pics of guns with a Z-Grip with a machined or grinded foregrip extender. What is the best way to go about doing this? Thanks.

[aNtHrAx323]

I just looked at mine closely, looked at what needed to go, and ground that sucker down :D . Now it fits perfectly. I used a grinding wheel... you can also use a Dremel, but that's a wee bit more interesting, hehe :)

[BlackVCG]

Here's mine. This was done with a hack saw and a needle file. Just mark the limits of what you want to cut out with a scribe, then use the hack saw and cut slits through the area you want to remove. Then you can pound out the thin pieces of aluminum and a use a flat needle file to smooth it down to where it fits properly. Use a hand hack saw, not an electric reciprocating saw.

http://www.automags.org/~BlackVCG/Z-Grip/KAPP.JPG

[virus]

of course if you have access to a bridgeport you can also do it that way (its how i did mine)

doing personal... er..... goverment work at work is always a good thing..... *8P

[TheBigRaguPB4L]

i cut the trigger gaurd. kinda dumb, but oh well, get's the job done.

[rhino]

Thanks for all the advice. I am going to give it a shot tomorrow.