View Full Version : DW CF Barrel insert stuck?
kcombs9
05-18-2009, 09:59 PM
My SS freak insert is stuck in side... on my freak kit I just pushed it out when I took the front off. Any suggestions on getting them out? and should I lube it when I put them in so they don't stick?
chafnerjr
05-18-2009, 10:47 PM
I've never had this issue, but I would imagine that some schmegg is stuck in there so... dip it in luke warm water and try again.
kcombs9
05-18-2009, 11:55 PM
got it out with my finger stuck in it like a finger trap. some paint was on it but not a lot. it also seems like the insert is not flush with the end of the barrel so maybe if I thread it in too tight to the body it jammed it in some
TwilightG
05-19-2009, 06:57 AM
also check to make sure the o-ring didn't get dislodged
I mysteriously lost mine and I wouldn't doubt it was from pulling out an insert
BigEvil
05-19-2009, 08:41 AM
I take a big T handle allen wrench, and use the rubber coated T end to pull the inserts out when they get stuck.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.