View Full Version : Pneumag: Clippart MPA-3 part question
derfalpha
05-27-2009, 08:26 AM
Does anyone know if there is a part similar to the Clippard MPA-3 part, but with more stroke?
http://www.pbupload.com/data/500/medium/mpa3.PNG
Thanks!
What about an Autococker actuator?
Hilltop Customs
05-27-2009, 03:57 PM
how much longer do you need?
Do you need the other aspects the same?(ID, OD, spring return......)
why do you need a longer stroke for a pneumag?
derfalpha
05-27-2009, 07:08 PM
I would need likely 9mm.
ID & OD can remain the same.
Spring return would definitely have to increase. Exactly how much i'm not sure because I don't have one in front of me. Springs aren't a problem anyway. You can find them anywhere.
I need a longer stroke because i'm toying with bullpup ideas. 9mm is what i've calculated so far.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.