View Full Version : RT instant rapid fire
Wilson!
05-28-2009, 04:31 PM
I recently purchased an RT pro valve to upgrade my mag. When I installed the RT and turned on the HPA the gun instantly began to rapid fire without me pulling the trigger. I tried shortening the trigger rod but I got rapid fire again... any ideas?
xero28
05-28-2009, 04:32 PM
Check the On/Off o-rings and make sure the on/off pin is the correct length.
Spider-TW
05-28-2009, 04:47 PM
Which on/off does it have?
Make sure the field strip screw is at least snug.
Wilson!
05-28-2009, 05:17 PM
It looks like an RT on/off, all the o-rings are good. The on/off pin may be too short, I don't have anything to accurately measure it. On the skinny end it seems to have been ground down or broken off, it isn't smooth on the end.
Spider-TW
05-28-2009, 05:30 PM
Good ruler?
The stock pin should be right at .750 (3/4").
A short pin will be more than 1/32" shorter.
Anyone know if you can drop a quad o-ring into an RT Pro on/off cavity?
Wilson!
05-28-2009, 05:35 PM
This pin measures just under 1/2 inch, it must be my issue.
Spider-TW
05-28-2009, 05:41 PM
This pin measures just under 1/2 inch, it must be my issue.
:wow: That's pretty much like not having a pin...
Wilson!
05-28-2009, 07:41 PM
Thanks for the info!
maniacmechanic
05-28-2009, 08:00 PM
This pin measures just under 1/2 inch, it must be my issue.
evidently sir , you have a broken pin :(
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.